Cold Air Intake - High-flow, Aluminum Tube - HONDA ACCORD V6-3.0L , POLISHE

479,99 $
Auf Lager
SKU
69-1207TP
The K&N 69-1207TP Typhoon cold-air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit some Honda Accord 3.0L V6 models. The restrictive factory air filter and air intake housing are replaced by the K&N Typhoon cold-air intake which is designed to pull in relatively cooler air and dramatically reduce air flow restriction by smoothing and straightening air flow. This allows your engine to inhale a larger amount of denser air than the factory air intake. More air means more usable power and acceleration throughout the engine's RPM range. The 69-1207TP cold-air intake consists of a black rubber topped K&N high-flow air filter that mounts near the driver side wheel well. The oversized cone shaped air filter comes with a water repellent DryCharger filter wrap to protect the filter from moisture. The air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This cold air intake is relatively easy to install usually in 90 minutes or less using existing factory mounting points. Some Typhoon air intakes are not legal for sale or use in California and other states adopting California emission standards while others are CARB exempt and 50 state legal. Check the K&N catalog or website for vehicle applications and specific CARB status for each vehicle and air intake.
  • Guaranteed to increase horsepower
  • Designed to improve throttle response and engine sound
  • Free-flowing aluminum tubes
  • Easy to install, usually in 90 minutes or less
  • Filter lasts up to 100,000 miles before service is required
  • Replaces entire factory air intake system
  • Washable and reusable lifetime air filter
  • K&N Million Mile Limited Warranty
Estimated Horsepower Gain10.35 HP @ 5522 RPM
Replacement FilterRU-4960
Air Filter FarbeRed
Air Filter MaterialCotton Gauze
Air Filter Outlet ShapeRound
Clamps Included5
Clamp MaterialStainless Steel
Clamp StyleRegular
Couplers Included2
System TypeComplete Cold-Air Intake System
Produkt Stil69 Series Typhoon Kits
Intake Pipe Farbe / FinishPolished
Intake Pipe MaterialAluminum
CARB EO NumberD-269-37
Street Legal In All US StatesYes
TUV Approved (Europe)No
Gewicht6.2 lb (2.8 kg)
Produkt Box Höhe8.5 in (216 mm)
Produkt Box Länge18.25 in (464 mm)
Produkt Box Breite14.5 in (368 mm)
Mounting Hardware IncludedYes
WarrantyNo-Hassle Lifetime Limited
No cross references found for this part
+10.35

pferdestarke

Recommended Products

Search By Vehicle
*
Search By Dimension
Der Artikel, den Sie in den Einkaufswagen gelegt haben, PASST NICHT zu Ihrem
Dieser Artikel passt zu Ihrem

Der folgende Artikel passt zu Ihrem Fahrzeug